Waterproof Film Camera – Frequently Asked Questions (FAQ)
General Information
Q: What comes in the box with my camera?
A: Your package includes:
1 x Waterproof Film Camera
1 x IPX8 Waterproof Case
1 x Wrist Strap*
1 x Pre-installed 35mm colour film (10 exposures)*
1 x User Guide*
1 x Warranty Certificate*
(*Some items may not be pictured in packaging.)
Film & Photos
Q: What type of film does the camera use?
A: The camera uses standard 35mm colour film. Only use film types compatible with this camera.
Q: How many photos can I take with the pre-installed film?
A: The included film reel has 10 exposures. After finishing, you can replace it with any standard 35mm film roll.
Q: How do I load a new roll of film?
A:
Ensure the old roll is fully rewound.
Open the back using the side latch.
Lift the winder, remove the old roll, and insert a new 35mm film.
Pull the film across and attach it to the take-up reel.
Close the back and wind the film to the first frame before shooting.
Q: How do I rewind the film when it’s finished?
A:
Flip out the winder handle on top.
Press and hold the button on the bottom.
Turn the winder clockwise until the roll is fully rewound.
Open the back and remove the film safely.
Q: Do I need to process the film immediately?
A: Yes, it is recommended to process exposed film promptly to avoid image degradation over time.
Using the Camera
Q: How do I take a photo?
A:
Look through the viewfinder to frame your shot.
Stand 1–3 metres from your subject.
Press the shutter button.
Wind the film forward to the next frame.
Q: How can I get the best results with this camera?
A:
Shoot in sunny or partly sunny weather.
Keep the sun behind you.
Ensure subjects are between 1–3 metres away.
Q: How do I check how many photos I’ve taken?
A: The exposure counter shows up to 10 frames. If using longer rolls, you’ll need to track additional exposures manually.
Waterproof Case
Q: How waterproof is the case?
A: The included IPX8 waterproof case protects the camera up to 3 metres deep for 30 minutes. Always ensure the case is securely locked before submersion.
Q: How do I install the camera into the waterproof case?
A:
Open the locking clip and swing open the case door.
Place the camera inside the case the correct way up.
Close the case and secure the locking clip.
Q: What if the case is not properly sealed?
A: If not correctly locked, water may enter and damage the camera. Always double-check the seal before use in water.
Safety & Care
Q: How should I care for the camera?
A:
Keep it in a cool, dry place away from direct sunlight.
Do not expose to high heat, dust, or humidity.
Handle the shutter gently and avoid dropping.
Regularly clean the lens and viewfinder.
Q: What should I do if the camera gets wet?
A: Dry it immediately and store it in a ventilated place. If damage occurs, seek professional repair.
Q: Can I repair the camera myself?
A: No, disassembling or repairing the camera yourself may cause permanent damage. Always use professional services.
Download Manual Below